Wash 101 & FAQ

How the station works, what running one involves day to day, and the answers buyers ask before they order.

The customer journey

The station runs a single six-step programme: sanitising → pre-wash → shampoo → conditioner → rinse → blow-dry. The customer pays at the touchscreen, works through each step, and the cabin runs a sanitising cycle between visits so the next dog starts clean.

What the operator does

  • Refill the fresh water — the unit holds 40 L (10.6 US gal). Top it up according to how many washes you run; there is no waste tank, waste goes straight to drainage.
  • Restock chemicals — four reservoirs (shampoo + conditioner) as standard, expandable to six. Swap the drums roughly once a week at typical volumes.
  • Keep it clean — a two-minute wipe-down of the cabin a few times a day keeps it appealing and protects the stainless surfaces.
  • Check the drain trap — clear hair from the drain module (150 × 300 mm) as part of your daily routine.

Installation footprint

The wash cabin and the side control cabinet join with no gap, giving an overall footprint of 1,350 mm wide × 1,400 mm deep × 1,900 mm high (53.1 × 55.1 × 74.8 in) — about 1.89 m². Allow roughly 1 m of clear space in front of the cabin for the customer and their dog.

The unit arrives in two pieces: the main unit at 180 kg (397 lb) and the wash cabin at 100 kg (220 lb). Both can be moved through a standard commercial doorway and positioned by two people — no crane or forklift required on site.

Power requirements

The station is supplied in two factory configurations. Choose the version that matches your region when ordering:

Europe / UK / Australia 230 V / 50 Hz build
United States / Canada 110 V / 60 Hz build
Installed power 12.05 kW total — blow-dry fan 3,000 W plus 9,050 W instantaneous and pre-heat
Supply current at 230 V Approx. 52 A

This is not a plug-into-a-wall-socket installation. The station needs a dedicated electrical circuit sized by a qualified electrician for your building. On a 230 V build that is roughly 52 A, which in practice means a dedicated circuit — and often a three-phase supply. On a 110 V build the current figures are higher still, so the circuit must be designed by your electrician for the US version. Please have your electrician review the rated power before you place the order; we supply the electrical specification sheet with the quotation.

Water and drainage

Fresh water is held in an integrated 40 L tank that you refill, so a fixed water supply is useful but not strictly required for low volumes. Drainage, however, is required: there is no waste-water tank, so the unit must be connected to building drainage through the 150 × 300 mm drain module using a 110 mm drain pipe.

Confirm your landlord allows the drain connection before installation — in most retail units this is a matter of tapping into an existing floor drain or stack.

Site checklist

Floor space 1.35 × 1.4 m plus 1 m clearance in front
Floor loading Level, hard floor able to carry 280 kg (617 lb) total
Electrical Dedicated circuit, 12.05 kW installed — sized by your electrician
Drainage 110 mm drain connection — no waste tank on the unit
Water fill Access to a tap, or a portable fill for the 40 L tank
Headroom 2,100 mm to accommodate the 1,900 mm unit
Ingress protection IPX6 — suitable for a wash-down area
Not sure whether your site is suitable? Send us a photo of the space, the position of the electrical panel and the nearest drain, and we will tell you what is required before you commit. Talk to our team.